Required Information for Calibration or Verification of Measuring Instruments
Thermometers
- Type of service: Verification or Calibration
- Type of thermometer: (Digital, Glass, Pyrometer, etc.)
- Measurement range: (Minimum and maximum measurable temperature in °C)
- Scale resolution: (Smallest scale division)
- Calibration points: (Specify exact temperatures in °C for calibration)
Flow Meters
- Type of service: Verification or Calibration
- Type of instrument: (Electromagnetic, Vortex, etc.)
- Instrument model: (e.g., Mag xxx, Promag, Vortex, etc.)
- Manufacturer
- Type approval mark: (If verification is requested)
- Pipe connection diameter (DN)
- Connection type: (Threaded, Sandwich, Flanged, etc.)
- Tested medium: (Cold water, Hot water, Steam, Liquids other than water)
- Maximum flow rate: (in m³/h)
- Number of calibration points: (Specify exact flow rates in m³/h if calibration is required)
- Required certification: (Whether a calibration certificate is required or just a verification mark)
Level Meters
- Type of service: Verification or Calibration
- Type of level meter: (Specify the exact type)
Breath Analyzers
- Manufacturer and model
- Type of verification: Initial verification or periodic re-verification
- Service status: Confirmation if the analyzer was adjusted at a service center before submitting the verification request
Scales
- Type of service: Verification or Calibration
- Maximum weighing capacity
- Accuracy class of the scale: (Class I, II, III)
- Important Note: For verification and calibration of Class I precision scales, the metrological service must be performed on-site at the customer's location.
- Customer address: Required for travel cost estimation if an on-site visit is necessary.
Weights
- Weight class or precision category
- Number of weights to be sent for verification or calibration
- Individual weights: List of weights by mass (e.g., 1 kg, 500 g, 100 g, etc.)
|
